Reference Guide

Interfaces | 579
Defaults
Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes
CONFIGURATION
Command History
Example
Figure 18-17. interface vlan Command Example
Usage Information
For more information on VLANs and the commands to configure them, refer to Virtual LAN (VLAN)
Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in
VLANs. IP ACLs are supported. See Chapter 6, Access Control Lists (ACL).
Related
Commands
ipg (Gigabit Ethernet interfaces)
e
Set the Inter-packet gap (IPG) to 8 bytes for traffic on a Gigabit Ethernet interface.
Syntax
ipg 8
To return to the default setting, enter no ipg.
Parameters
Defaults
12 bytes
Command Modes
INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Support for 4093 VLANs on E-Series ExaScale. Prior releases supported 2094.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.0 Introduced for E-Series
FTOS(conf)#int vlan 3
FTOS(conf-if-vl-3)#
interface Configure a physical interface.
interface loopback Configure a loopback interface.
interface null Configure a null interface.
interface port-channel Configure a port channel group.
show vlan Display the current VLAN configuration on the switch.
shutdown Disable/Enable the VLAN.
tagged Add a Layer 2 interface to a VLAN as a tagged interface.
untagged Add a Layer 2 interface to a VLAN as an untagged interface.
8 Enter the keyword 8 to set the IPG to 8 bytes.
Version 8.2.1.0 Support for 4093 VLANs on E-Series ExaScale. Prior releases supported 2094.
Version 8.1.1.0 Introduced on E-Series ExaScale
pre-Version 6.1.1.0 Introduced for E-Series