Reference Guide

58 | File Management
www.dell.com | support.dell.com
restore fpga-image
c
Copy the backup C-Series FPGA image to the primary FPGA image.
Syntax
restore fpga-image {rpm | linecard} number
Parameters
Defaults
None.
Command Mode
EXEC Privilege
Command
History
Example
Figure 3-15. Command example: restore fpga-image
Usage
Information
Reset the card using the power-cycle option after restoring the FPGA command.
Related
Commands
upgrade fpga-image
c
Upgrade the primary FPGA image.
Syntax
upgrade fpga-image {rpm {number | all}| linecard {number | all} [system-fpga | link-fpga] | all}
{booted | file-url}
rpm Enter rpm to upgrade an RPM FPGA.
linecard Enter linecard to upgrade a line card FPGA.
number
Enter the line card or RPM slot number.
C-Series Line Card Range: 0-7, RPM Range: 0-1
Version 7.7.1.0
Renamed keyword
primary-fpga-flash to fpga-image.
Version 7.5.1.0 Introduced on C-Series
FTOS#restore fpga-image linecard 4
Current FPGA information in the system:
=======================================
Card FPGA Name Current Version New Version
------------------------------------------------------------------------
LC4 48 Port 1G LCM FPGA A: 3.6 restore
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Restore fpga image for linecard 4 [yes/no]: yes
FPGA restore in progress. Please do NOT power off the card.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Upgrade result :
================
Linecard 4 FPGA restore successful.
reset Reset a card.