Reference Guide

Control and Monitoring | 61
4
Control and Monitoring
Overview
This chapter contains the following commands to configure and monitor the system,
including Telnet, FTP, and TFTP as they apply to the following Dell Force10 platforms
e
E-Series, c C-Series, s S-Series, z Z-Series or .
Commands
Note: Beginning in release 8.3.11.4, the enable xfp-power-updates command was
deprecated for the Z9000. It was replaced by the enable optic-info-update interval
command to update information on temperature and power monitoring in the SNMP
MIB.
asf-mode send
audible cut-off service timestamps
banner exec show alarms
banner login show chassis
banner motd show command-history
cam-audit linecard show command-tree
clear alarms show console lp
clear command history show cpu-traffic-stats
clear line show debugging
configure show environment (C-Series and E-Series)
debug cpu-traffic-stats show environment (S-Series)
debug ftpserver show inventory (C-Series and E-Series)
disable show inventory (S-Series and Z-Series)
do show linecard
enable show linecard boot-information
enable optic-info-update interval show memory (C-Series and E-Series)
enable xfp-power-updates show memory (S-Series)
end show processes cpu (C-Series and E-Series)