Reference Guide

66 | Control and Monitoring
www.dell.com | support.dell.com
This is the banner
FTOS>
banner motd
c e s z
Set a Message of the Day (MOTD) banner.
Syntax
banner motd c line c
To delete a Message of the Day banner, enter no banner motd.
Parameters
Defaults
No banner is configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
A MOTD banner message is displayed only in EXEC Privilege mode after entering the
enable command followed by the password. These banners are not displayed to users in
EXEC (non-privilege) mode.
Related
Commands
cam-audit linecard
e
Enable audit of the IPv4 forwarding table on all line cards.
Syntax
cam-audit linecard all ipv4-fib interval time-in-minutes
To disable audit, use the no cam-audit linecard all ipv4-fib command
c Enter a delineator character to specify the limits of the text banner. In the above
figures, the % character is the delineator character.
line Enter a text string for your message of the day banner message ending the message
with your delineator.
In the example figures above, the delineator is a percent character (%).
Version 8.3.11.1 Introduced on the Z9000
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
banner exec Sets a banner to be displayed when you enter the EXEC Privilege mode.
banner login Sets a banner to be displayed after successful login to the system.