Reference Guide

IPv4 Routing | 675
Command Modes
EXEC
EXEC Privilege
Command History
Example
Figure 19-20. show ip route all Command Example
Example
Figure 19-21. show ip route summary and show ip route static Command Examples
connected (OPTIONAL) Enter the keyword connected to view only the directly
connected routes.
all (OPTIONAL) Enter the keyword all to view both active and non-active routes.
static (OPTIONAL) Enter the keyword static to view only routes configured by the
ip route command.
summary (OPTIONAL) Enter the keyword summary. See show ip route summary.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.9.1.0 Introduced VRF on the E-Series
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series
FTOS#show ip route all
Codes: C - connected, S - static, R - RIP
B - BGP, IN - internal BGP, EX - external BGP, LO - Locally Originated
O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default
> - non-active route + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 3.0.0.0/8 via 100.10.10.10, So 2/8 120/1 00:07:12
via 101.10.10.10, So 2/9
C 100.10.10.0/24 Direct, So 2/8 0/0 00:08:54
> R 100.10.10.0/24 Direct, So 2/8 120/0 00:08:54
C 101.10.10.0/24 Direct, So 2/9 0/0 00:09:15
> R 101.10.10.0/24 Direct, So 2/9 120/0 00:09:15
FTOS#
FTOS#show ip route summary
Route Source Active Routes Non-active Routes
connected 2 0
static 1 0
Total 3 0
Total 3 active route(s) using 612 bytes
R1_E600i>show ip route static ?
| Pipe through a command
<cr>
R1_E600i>show ip route static
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
*S 0.0.0.0/0 via 10.10.91.9, Gi 1/2 1/0 3d2h
FTOS>