Reference Guide

712 |
www.dell.com | support.dell.com
Parameters
Defaults
multiplier =3; level-1 (if not otherwise specified)
Command Modes
INTERFACE
Usage
Information
The holdtime (the product of the hello-multiplier multiplied by the hello-interval) determines how long
a neighbor waits for a hello packet before declaring the neighbor is down so routes can be
recalculated.I
Related
Commands
isis hello padding
e
Turn ON or OFF padding of hello PDUs from the interface mode.
Syntax
isis hello padding
To return to the default, use the no isis hello padding.
Defaults
Padding of hello PDUs is enabled (ON).
Command Modes
INTERFACE
Usage
Information
Hello PDUs are “padded” only when both the global and interface padding options are ON. Turning
either one OFF will disable padding for the corresponding interface(s).
Related
Commands
isis ipv6 metric
e z
Assign metric to an interface for use with IPv6 information.
Syntax
isis ipv6 metric default-metric [level-1 | level-2]
To return to the default values, enter no ipv6 isis metric [default-metric] [level-1 | level-2]
command.
multiplier
Specifies an integer that sets the multiplier for hello holding time.
Never configure a hello-multiplier lower then the default (3).
Range: 3 to 1000
Default: 3
level-1
(OPTIONAL) Select this value to configure the hello multiplier independently for Level 1
adjacencies.
This is the default.
level-2
(OPTONAL) Select this value to configure the hello multiplier independently for Level 2
adjacencies.
isis hello-interval Specify the length of time between hello packets.
hello padding Turn ON or OFF padding for LAN and point-to-point hello PDUs.