Reference Guide

72 | Control and Monitoring
www.dell.com | support.dell.com
Usage
Information
Users entering the EXEC Privilege mode or any other configured privilege level can access
configuration commands. To protect against unauthorized access, use the
enable password
command to configure a password for the enable command at a specific privilege level. If no
privilege level is specified, the default is privilege level 15.
Related
Commands
enable optic-info-update interval
Z
Enable polling intervals of optical information updates for SNMP.
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-info-update interval
command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
The default interval for the polling is 300 seconds (5 minutes). Use this command to enable
the polling and to configure the polling frequency.
enable xfp-power-updates
c e s
Enable XFP power updates for SNMP.
Syntax
enable xfp-power-updates interval seconds
To disable XFP power updates, use the no enable xfp-power-updates command.
Parameters
Defaults
Disabled
enable password Configure a password for the enable command and to access a privilege level.
interval seconds
Enter the keyword interval followed by the polling interval in seconds.
Range: 120 to 6000 seconds
Default: 300 seconds (5 minutes)
Version 8.3.11.4 Introduced on Z9000 to replace the enable xfp-power-updates
command.
Version 8.3.10.0 Replacement command for S4810. Replaces the enable
xfp-power-updates
command.
interval seconds
Enter the keyword interval followed by the polling interval in seconds.
Range: 120 to 6000 seconds
Default: 300 seconds (5 minutes)