Reference Guide

732 |
www.dell.com | support.dell.com
show isis protocol
e
Display IS-IS routing information.
Syntax
show isis protocol
Command Modes
EXEC
EXEC privilege
Example
Figure 21-9. Command Example: show isis protocol
show isis traffic
e
This command enables you to display IS-IS traffic interface information.
Syntax
show isis traffic [interface]
Parameters
Command Modes
EXEC
EXEC privilege
FTOS#show isis protocol
IS-IS Router: <Null Tag>
System Id: F100.E120.0013 IS-Type: level-1-2
Manual area address(es):
49.0000.0001
Routing for area address(es):
49.0000.0001
Interfaces supported by IS-IS:
GigabitEthernet 1/0 - IP - IPv6
GigabitEthernet 1/1 - IP - IPv6
GigabitEthernet 1/10 - IP - IPv6
Loopback 0 - IP - IPv6
Redistributing:
Distance: 115
Generate narrow metrics: level-1-2
Accept narrow metrics: level-1-2
Generate wide metrics: none
Accept wide metrics: none
Multi Topology Routing is enabled in transition mode.
FTOS#
Identifies that MT IS-IS
is enabled.
interface
(OPTIONAL) Identifies the interface type slot/port as one of the following:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a Port Channel, enter the keyword
port-channel followed by a number from 1
to 32 for EtherScale, 1 to 255 for TeraScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.