Reference Guide

762 | Layer 2
www.dell.com | support.dell.com
tagged
c e s z
Add a Layer 2 interface to a VLAN as a tagged interface.
Syntax
tagged interface
To remove a tagged interface from a VLAN, use no tagged interface command.
Parameters
Defaults
All interfaces in Layer 2 mode are untagged.
Command Modes
INTERFACE VLAN
Command
History
Usage
Information
When you use the no tagged command, the interface is automatically placed in the Default
VLAN as an untagged interface unless the interface is a member of another VLAN. If the
interface belongs to several VLANs, you must remove it from all VLANs to change it to an
untagged interface.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can only belong
to one VLAN at a time.
Related
Commands
track ip
c e s z
Track the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member
interfaces.
Syntax
track ip interface
To remove the tracking feature from the VLAN, use the no track ip interface command.
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
interface vlan Configure a VLAN.
untagged Specify which interfaces in a VLAN are untagged.