Reference Guide

764 | Layer 2
www.dell.com | support.dell.com
Parameters
Defaults
All interfaces in Layer 2 mode are untagged.
Command Modes
INTERFACE VLAN
Command
History
Usage
Information
Untagged interfaces can only belong to one VLAN.
In the Default VLAN, you cannot use the no untagged
interface command. To remove an
untagged interface from all VLANs, including the Default VLAN, enter the INTERFACE
mode and use the no switchport command.
Related
Commands
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For Port Channel interface types, enter the keyword
port-channel followed by a
number from 1 to 255 for TeraScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
interface vlan Configure a VLAN.
tagged Specify which interfaces in a VLAN are tagged.