Reference Guide

768 | Layer 2
www.dell.com | support.dell.com
fefd reset
e z
Reset all interfaces or a single interface that was in “error-disabled” mode.
Syntax
fefd reset [interface]
Parameters
Defaults
Not configured.
Command Modes
EXEC Privilege
Related
Commands
Command
History
show fefd
e z
View FEFD status globally or on a specific interface.
Syntax
show fefd [interface]
Parameters
Command Modes
EXEC
EXEC Privilege
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a SONET interface, enter the keyword
sonet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/
port information.
fefd Enable Far-End Failure Detection.
Version 9.0.0.0 Introduced on Z9000
Version 8.3.12.0
Introduced on S4810.
Legacy E-Series command
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a SONET interface, enter the keyword
sonet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/
port information.