Reference Guide

Link Layer Detection Protocol (LLDP) | 777
Related
Commands
multiplier
c e s z
Set the number of consecutive misses before LLDP declares the interface dead.
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
Defaults
4 x hello
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
protocol lldp (Configuration)
c e s z
Enable LLDP globally on the switch.
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults
Disabled
Command Modes
CONFIGURATION (conf-lldp)
Command
History
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
protocol lldp (Configuration) Enable LLDP globally.
show lldp neighbors Display the LLDP neighbors
integer
Enter the number of consecutive misses before the LLDP declares the interface dead.
Range: 2 - 10
Version 8.3.11.1 Introduced on the Z9000.
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
Version 8.3.11.1 Introduced on the Z9000.
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series