Reference Guide

782 | Link Layer Detection Protocol (LLDP)
www.dell.com | support.dell.com
Parameters
Defaults
unconfigured
Command Modes
CONFIGURATION (conf-lldp)
Command
History
\
Related
Commands
advertise med location-identification
c e s z
Configure the system to advertise a location identifier.
Syntax
advertise med location-identification {coordinate-based value | civic-based value | ecs-elin value}
To return to the default, use the no advertise med location-identification {coordinate-based value |
civic-based value | ecs-elin value} command.
Parameters
Defaults
unconfigured
Command Modes
CONFIGURATION (conf-lldp)
Command
History
vlan-id
Enter the VLAN ID.
Range: 1 to 4094
layer2_priority
Enter the Layer 2 priority.
Range: 0 to 7
DSCP_value
Enter the DSCP value.
Range: 0 to 63
priority-tagged number Enter the keyword priority-tagged followed the Layer 2 priority.
Range: 0 to 7
Version 8.3.11.1 Introduced on the Z9000.
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series and E-Series
debug lldp interface Debug LLDP
show lldp neighbors Display the LLDP neighbors
show running-config lldp Display the LLDP running configuration
coordinate-based value Enter the keyword coordinate-based followed by the coordinated based
location in hexadecimal value of 16 bytes.
civic-based value Enter the keyword civic-based followed by the civic based location in
hexadecimal format.
Range: 6 to 255 bytes
ecs-elin value
Enter the keyword ecs-elin followed by the Emergency Call Service (ecs)
Emergency Location Identification Number (
elin) numeric location string.
Range: 10 to 25 characters
Version 8.3.11.1 Introduced on the Z9000.
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series and E-Series