Reference Guide

Multicast Source Discovery Protocol (MSDP) | 791
Defaults
Without any options, this command clears the entire source-active cache.
Command Modes
EXEC Privilege
Command
History
debug ip msdp
e z
Turn on MSDP debugging.
Syntax
debug ip msdp {event peer address | packet peer address | pim}
To turn debugging off, use the no debug ip msdp {event peer address | packet peer address |
pim} command.
Parameters
Defaults
Not configured
Command Modes
EXEC Privilege
Command
History
ip msdp cache-rejected-sa
e z
Enable a MSDP cache for the rejected source-active entries.
Syntax
ip msdp cache-rejected-sa {number}
To clear the MSDP rejected source-active entries, use the no ip msdp cache-rejected-sa {number}
command followed by the ip msdp cache-rejected-sa {number} command.
Parameters
Defaults
No default values or behavior
Version 8.3.11.1 Introduced n the Z9000
Version 8.3.7.1 Introduced on the S4810
Version 7.8.1.0
Added
local option.
Version 7.7.1.0
Added
rejected-sa option.
Version 6.2.1.1 Introduced
event peer address
Enter the keyword event followed by the peer address in a dotted decimal
format (A.B.C.D.).
packet peer address Enter the keyword packet followed by the peer address in a dotted decimal
format (A.B.C.D.).
pim Enter the keyword pim to debug advertisement from PIM.
Version 8.3.11.1 Introduced n the Z9000
Version 8.3.7.1 Introduced on the S4810
Version 6.2.1.1 Introduced
number
Enter the number of rejected SA entries to cache.
Range: 0 to 32766