Reference Guide

Multicast Source Discovery Protocol (MSDP) | 797
Usage
Information
FTOS counts the SA messages originated by itself and those received from the MSDP peers. When the
total SA messages reach this limit, the subsequent SA messages are dropped (even if they pass RPF
checking and policy checking). If the total number of SA messages is already larger than the limit
when this command is applied, those SA messages that are already in FTOS will continue to be
accepted. To enforce the limit in such situation, use the clear ip msdp sa-cache command.
Related
Commands
ip msdp shutdown
e z
Administratively shut down a configured MSDP peer.
Syntax
ip msdp shutdown {peer address}
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
ip multicast-msdp
e z
Enable MSDP.
Syntax
ip multicast-msdp
To exit MSDP, use the no ip multicast-msdp command.
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
ip msdp peer Configure the MSDP peer
clear ip msdp peer Clear the MSDP peer.
show ip msdp Display the MSDP information
peer address
Enter the peer address in a dotted decimal format (A.B.C.D.)
Version 8.3.11.1 Introduced n the Z9000
Version 8.3.7.1 Introduced on the S4810
Version 6.2.1.1 Introduced
Version 8.3.11.1 Introduced n the Z9000
Version 8.3.7.1 Introduced on the S4810
Version 6.2.1.1 Introduced