Reference Guide

Multicast | 817
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Related
Commands
ip multicast-lag-hashing
e
Distribute multicast traffic among Port Channel members in a round-robin fashion.
Syntax
ip multicast-lag-hashing
To revert to the default, enter no ip multicast-lag-hashing.
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
By default, one Port Channel member is chosen to forward multicast traffic. With this feature turned
on, multicast traffic will be distributed among the Port Channel members in a round-robin fashion.
This feature applies to the routed multicast traffic. If IGMP Snooping is turned on, this feature also
applies to switched multicast traffic.
Related
Commands
ip multicast-routing
c e s z
Enable IP multicast forwarding.
Syntax
ip multicast-routing
To disable multicast forwarding, enter no ip multicast-routing.
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
You must enter this command to enable multicast on the E-Series.
After you enable multicast, you can enable IGMP and PIM on an interface. In the INTERFACE mode,
enter the ip pim sparse-mode command to enable IGMP and PIM on the interface.
Version 8.3.11.1 Introduced on S4810
E-Series legacy command
show ip mroute View the E-Series routing table.
Version 6.3.1.0 Introduced for E-Series
ipv6 multicast-routing
Enable IP multicast forwarding.
Version 8.3.11.1 Introduced on S4810
E-Series legacy command