Reference Guide

818 | Multicast
www.dell.com | support.dell.com
Related
Commands
ip multicast-limit
c e s z
Use this feature to limit the number of multicast entries on the system.
Syntax
ip multicast-limit limit
Parameters
Defaults
As above
Command Modes
CONFIGURATION
Command
History
Usage
Information
This features allows the user to limit the number of multicast entries on the system. This number is the
sum total of all the multicast entries on all line cards in the system. On each line card, the multicast
module will only install the maximum possible number of entries, depending on the configured CAM
profile.
The IN-L3-McastFib CAM partition is used to store multicast routes and is a separate hardware limit
that is exists per port-pipe. Any software-configured limit might be superseded by this hardware space
limitation. The opposite is also true, the CAM partition might not be exhausted at the time the
system-wide route limit set by the ip multicast-limit is reached.
Related
Commands
mac-flood-list
e
Provide an exception to the restrict-flood configuration so that multicast frames within a specified
MAC address range to be flooded on all ports in a VLAN.
Syntax
mac-flood-list mac-address mask vlanvlan-list [min-speed speed]
Parameters
ip pim sparse-mode Enable IGMP and PIM on an interface.
limit
Enter the desired maximum number of multicast entries on the system.
E-Series Range: 1 to 50000
E-Series Default: 15000
C-Series Range: 1 to 10000
C-Series Default: 4000
S-Series Range: 1 to 2000
S-Series Default: 400
Version 8.3.11.1 Introduced on S4810
Version 7.8.1.0 Introduced on C-Series
Version 7.6.1.0 Introduced on E-Series
show ip igmp groups
mac-address
Enter a multicast MAC address in hexadecimal format.
mac-mask
Enter the MAC Address mask.