Reference Guide

Control and Monitoring | 85
Usage
Information
Use this command only for empty slots or a slot where you have hot-swapped a different line
card type. Before inserting a card of a different type into the pre-configured slot, execute the
no linecard
number command. The following screenshot shows the current supported
C-Series line cards, along with their “card types” (card-type IDs).
Example
(C-Series)
FTOS#show linecard 3
-- Line card 11 --
Status : not present
FTOS#linecard 3 ?
E46TB 36-port GE 10/100/1000Base-T with RJ45 - 8-port FE/GE with SFP - 2-port
10GE with SFP+
E46VB 36-port GE 10/100/1000Base-T with RJ45 and PoE - 8-port FE/GE with SFP -
2-port 10GE with SFP+
E48PB 48-port FE/GE line card with SFP optics (CB)
E48TB 48-port GE 10/100/1000Base-T line card with RJ45 interfaces (CB)
E48VB 48-port GE 10/100/1000Base-T line card with RJ45 interfaces and PoE (CB)
EX4PB 4-port 10GE LAN PHY line card with XFP optics (CB)
EX8PB 8-port 10GE LAN PHY line card with XFP optics (CB)
FTOS#linecard 3 EX4PB
FTOS#show linecard 3
-- Line card 11 --
Status : not present
Required Type : EX4PB - 4-port 10GE LAN PHY line card with XFP optics (CB)
FTOS#
Related
Commands
linecard (4-port 40G line card)
e
x
Pre-configure an empty slot in an E-Series ExaScale switch for a 4-port 40
GigabitEthernet line card or reconfigure a slot in which you have hot-swapped a
4-port 40G line card.
Syntax
linecard slot-number card-type {linerate | oversubscribed} active-ports
port-set0
port-number [port-number] port-set1 port-number [port-number]
Parameters
show linecard Display the line card(s) status.
slot-number Enter the slot number in which you will use the line card.
Range: 0 - 13 on an E1200i; 0 - 5 on an E600i.
card-type Enter the line card ID. Valid values are:
EX04PH: Configures the slot for a 6-port 40GE line card with 10M CAM
(LC-EH-40GE-4P).
EX04PJ: Configures the slot for a 6-port 40GE line card with 40M CAM
(LC-EJ-40GE-4P).
linerate Configure two ports on the line card to transmit data at full line rate (40 Gbps).
oversubscribed Configure four ports on the line card for oversubscribed data transmission.
active-ports Enable the active ports for the specified mode (linerate or oversubscribed).