Reference Guide

Open Shortest Path First (OSPFv2) | 853
log-adjacency-changes
c e s z
Set FTOS to send a Syslog message about changes in the OSPF adjacency state.
Syntax
log-adjacency-changes
To disable the Syslog messages, enter no log-adjacency-changes.
Defaults
Disabled.
Command Mode
ROUTER OSPF
Command
History
maximum-paths
c e s z
Enable the software to forward packets over multiple paths.
Syntax
maximum-paths number
To disable packet forwarding over multiple paths, enter no maximum-paths.
Parameters
Defaults
4
Command Modes
ROUTER OSPF
Command
History
Version 8.3.11.1 Introduced on Z9000
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
number
Specify the number of paths.
Range: 1 to 32
Default: 4 paths
Version 9.0.0.0 Range for parameter was increased from 16 to 32.
Version 8.3.11.1 Introduced on Z9000
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series