Reference Guide

854 | Open Shortest Path First (OSPFv2)
www.dell.com | support.dell.com
mib-binding
c e s z
Enable this OSPF process ID to manage the SNMP traps and process SNMP queries.
Syntax
mib-binding
To mib-binding on this OSPF process, enter no mib-binding.
Defaults
None.
Command Modes
ROUTER OSPF
Command
History
Usage
Information
This command is either enabled or disabled. If no OSPF process is identified as the MIB manager, the
first OSPF process will be used.
If an OSPF process has been selected, it must be disabled prior to assigning new process ID the MIB
responsibility.
network area
c e s z
Define which interfaces run OSPF and the OSPF area for those interfaces.
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-id command.
Parameters
Command Modes
ROUTER OSPF
Command
History
Version 8.3.11.1 Introduced on Z9000
Version 7.8.1.0 Introduced to all platforms.
ip-address
Specify a primary or secondary address in dotted decimal format. The primary address
is required before adding the secondary address.
mask
Enter a network mask in /prefix format. (/x)
area-id
Enter the OSPF area ID as either a decimal value or in a valid IP address.
Decimal value range: 0 to 65535
IP address format: dotted decimal format A.B.C.D.
Note: If the area ID is smaller than 65535, it will be converted to a decimal
value. For example, if you use an area ID of 0.0.0.1, it will be converted to 1.
Version 8.3.11.1 Introduced on Z9000
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series