Reference Guide

966 | Quality of Service (QoS)
www.dell.com | support.dell.com
show cam layer3-qos
e
Display the Layer 3 QoS CAM entries.
Syntax
show cam layer3-qos {[linecard number port-set number] | [interface interface]}
[summary]
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
Command
History
Example
Figure 33-5. show cam layer3-qos linecard interface Command Output
In these figures outputs, note that:
• The entry TRUST-DSCP in the Queue column indicates that the trust diffserv is configured on the
policy-map.
• A hyphen (-) entry in the DSCP Marking column indicates that there is no DSCP marking.
• In the Proto column (Protocol), IP, ICMP, UDP, and TCP strings are displayed. For other
protocols, the corresponding protocol number is displayed.
linecard number
Enter the keyword linecard followed by the line card slot number.
E-Series Range: 0 to 13 on a E1200, 0 to 6 on a E600/E600i, and 0 to 5 on a
E300.
port-set number
Enter the keyword port-set followed by the line card’s port pipe.
Range: 0 or 1
interface interface Enter the keyword interface followed by one of the keywords below and
slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet
followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
summary (OPTIONAL) Enter the keyword summary to display only the total
number of CAM entries.
Version 6.5.1.0 Introduced on E-Series
FTOS#sh cam layer3-qos interface gigabitethernet 2/1
Cam Port Dscp Proto Tcp Src Dst SrcIp DstIp DSCP Queue
Index Flag Port Port Marking
--------------------------------------------------------------------------------------------
----
23488 1 0 0 0x0 0 0 0.0.0.0/0 0.0.0.0/0 - TRUST-DSCP
FTOS#