Reference Guide

Router Information Protocol (RIP) | 989
Command Modes
INTERFACE
Command
History
Usage
Information
To enable the interface to send both version of RIP packets, enter ip rip send version 1 2.
Related
Commands
ip split-horizon
c e s z
Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme
prevents any routes learned over a specific interface to be sent back out that interface.
Syntax
ip split-horizon
To disable split-horizon, enter no ip split-horizon.
Defaults
Enabled
Command Modes
INTERFACE
Command
History
Related
Commands
maximum-paths
c e s z
Set RIP to forward packets over multiple paths.
Syntax
maximum-paths number
To return to the default values, enter no maximum-paths.
Parameters
Defaults
4
Version 8.3.11.1 Introduced on Z9000
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
ip rip receive version Sets the RIP version for the interface to receive traffic.
version Sets the RIP version to be used for the switch software.
Version 8.3.11.1 Introduced on Z9000
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
ip poison-reverse Set the prefix for RIP routing updates.
number
Enter the number of paths.
Range: 1 to 16.
The default is 4 paths.