Reference Guide

Router Information Protocol (RIP) | 995
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
History
router rip
c e s z
Enter the ROUTER RIP mode to configure and enable RIP.
Syntax
router rip
To disable RIP, enter no router rip.
Defaults
Disabled.
Command Modes
CONFIGURATION
Command
History
Usage
Information
To enable RIP, you must assign a network address using the network command.
Example
Figure 34-1. router rip Command Example
Related
Commands
metric
metric-value
(OPTIONAL) Enter the keyword
metric followed by a number as the metric
value.
Range: 0 to16
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of a
configured route map.
Version 8.3.11.1 Introduced on Z9000
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
Version 8.3.11.1 Introduced on Z9000
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
FTOS(conf)#router rip
FTOS(conf-router_rip)#
network Enable RIP.
exit Return to the CONFIGURATION mode.