Reference Guide

NOTE: If you select the CAM profile from CONFIGURATION mode, the output of this command does not reflect any
changes until you save the running-configuration and reload the chassis.
Example of show running-config cam-profile Command
FTOS#show running-config cam-profile
!
cam-profile default microcode default
FTOS#
View CAM-ACL Settings
The show cam-acl command is supported on the platform.
View the current cam-acl settings using the show cam-acl command.
Example of Viewing CAM-ACL Settings
FTOS# show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 2
-- Line card 0 --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 2
Ipv4Qos : 2
L2Qos : 2
L2PT : 1
IpMacAcl : 2
VmanQos : 0
VmanDualQos : 0
EcfmAcl : 0
-- Line card 6 --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 2
Ipv4Qos : 2
L2Qos : 2
L2PT : 1
IpMacAcl : 2
VmanQos : 0
VmanDualQos : 0
EcfmAcl : 0
The default values for the show cam-acl command for the are:
Example of Viewing CAM-ACL Settings ()
FTOS#show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl : 4
Ipv4Acl : 4
Ipv6Acl : 0
210