Manualshelf

Reference Guide

ManualsBrandsDell ManualsComputer equipmentForce10 Z9000
541542543544545546547548549550
no disable
Disabling PVST+
To disable PVST+ globally or on an interface, use the following commands.
• Disable PVST+ globally.
PROTOCOL PVST mode
disable
• Disable PVST+ on an interface, or remove a PVST+ parameter configuration.
INTERFACE mode
no spanning-tree pvst
To display your PVST+ configuration, use the show config command from PROTOCOL PVST mode.
Example of Viewing PVST+ Configuration
FTOS_E600(conf-pvst)#show config verbose
!
protocol spanning-tree pvst
no disable
vlan 100 bridge-priority 4096
Influencing PVST+ Root Selection
As shown in the previous per-VLAN spanning tree illustration, all VLANs use the same forwarding topology because R2
is elected the root, and all GigabitEthernet ports have the same cost.
The following per-VLAN spanning tree illustration changes the bridge priority of each bridge so that a different
forwarding topology is generated for each VLAN. This behavior demonstrates how you can use PVST+ to achieve load
balancing.
541