Administrator Guide

default-
information-
originate
(OPTIONAL) Allows external routing information to be
imported into the NSSA by using Type 7 default.
no-summary (OPTIONAL) Specify that no summary LSAs should be sent
into the NSSA.
Defaults Not configured.
Command
Modes
ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for the Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
area range
Summarize routes matching an address/mask at an area border router (ABR).
Z9000
Syntax
area area-id range ip-address mask [not-advertise]
To disable route summarization, use the no area area-id range ip-address
mask
command.
Parameters
area-id Specify the OSPF area in dotted decimal format (A.B.C.D.) or
enter a number from zero (0) to 65535.
ip-address Specify an IP address in dotted decimal format.
mask Specify a mask for the destination prefix. Enter the full mask
(for example, 255.255.255.0).
not-advertise (OPTIONAL) Enter the keywords not-advertise to set the
status to DoNotAdvertise (that is, the Type 3 summary-LSA is
Open Shortest Path First (OSPFv2 and OSPFv3)
1031