Administrator Guide

Parameters
prefix-list-
name
Enter the name of a configured prefix list.
interface (OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For Port Channel groups, enter the keywords port-
channel then a number. For the C-Series and S-Series,
the range is from 1 to 128.
• For a SONET interface, enter the keyword sonet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults Not configured.
Command
Modes
ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for the Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
distribute-list out
To restrict certain routes destined for the local routing table after the SPF calculation, apply a filter.
Z-Series
Syntax
distribute-list prefix-list-name out [bgp | connected | isis |
rip | static]
1044
Open Shortest Path First (OSPFv2 and OSPFv3)