Administrator Guide

Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The distribute-list out command applies to routes autonomous system
boundary routers (ASBRs) redistributes into OSPF. It can be applied to external type
2 and external type 1 routes, but not to intra-area and inter-area routes.
enable inverse-mask
By default, Dell Networking Operating System (OS) allows you to input the OSPF network command
with a net-mask. This command provides a choice between inverse-mask or net-mask (the default).
Z9000
Syntax
enable inverse mask
To return to the default net-mask, use the no enable inverse mask command.
Defaults net-mask
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.1 Introduced on the S4810.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
fast-convergence
This command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid route
computation so that convergence takes less time.
Z9000
Syntax
fast-convergence {number}
To cancel fast-convergence, use the no fast convergence command.
1046
Open Shortest Path First (OSPFv2 and OSPFv3)