Administrator Guide

Defaults 5 seconds
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
Set the time interval to a number large enough to prevent unnecessary
retransmissions. For example, the interval must be larger for interfaces connected
to virtual links.
ip ospf transmit-delay
To send a link state update packet on the interface, set the estimated time elapsed.
Z9000
Syntax
ip ospf transmit-delay seconds
To return to the default value, use the no ip ospf transmit-delay command.
Parameters
seconds Enter the number of seconds as the interval between
retransmission. The range is from 1 to 3600. The default is 1
second.
This value must be greater than the transmission and
propagation delays for the interface.
Defaults 1 second
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
Open Shortest Path First (OSPFv2 and OSPFv3)
1059