Administrator Guide

passive-interface
Suppress both receiving and sending routing updates on an interface.
Z9000
Syntax
passive-interface {default | interface}
To enable both the receiving and sending routing, use the no passive-
interface interface command.
To return all OSPF interfaces (current and future) to active, use the no passive-
interface default command.
Parameters
default Enter the keyword default to make all OSPF interfaces
(current and future) passive.
interface Enter the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For Port Channel groups, enter the keywords port-
channel then a number. For the C-Series and S-Series,
the range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Command
Modes
ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Open Shortest Path First (OSPFv2 and OSPFv3)
1063