Administrator Guide

n]:
Dell#
router ospf
To configure an OSPF instance, enter ROUTER OSPF mode.
Z9000
Syntax
router ospf process-id
To clear an OSPF instance, use the no router ospf process-id command.
Parameters
process-id Enter a number for the OSPF instance. The range is from 1 to
65535.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.1(0.0) Added support for OSPFv3 on the S4810 and Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
You must have an IP address assigned to an interface to enter ROUTER OSPF mode
and configure OSPF.
Example
Dell(conf)#router ospf 2
Dell(conf-router_ospf)#
1070
Open Shortest Path First (OSPFv2 and OSPFv3)