Administrator Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Added output for LSA throttling timers.
Version 8.3.7.0 Introduced on the S4810.
Version 7.9.1.0 Added support for VRF.
Version 7.8.1.0 Added support of Multi-Process OSPF.
Version 7.8.1.0 Added the process-id option, in support of Multi-Process
OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
If you delete all the network area commands for Area 0, the show ip ospf
command output does not list Area 0.
The following describes the show ip ospf command shown in the following
example.
Line Beginning
with
Description
“Routing
Process...”
Displays the OSPF process ID and the IP address associated
with the process ID.
“Supports only...” Displays the number of Type of Service (TOS) rouse
supported.
“SPF schedule...” Displays the delay and hold time configured for this process
ID.
“Convergence
Level”
“Min LSA....” Displays the intervals set for LSA transmission and
acceptance.
“Number of...” Displays the number and type of areas configured for this
process ID.
Example
Dell#show ip ospf 10
Routing Process ospf 10 with ID 1.1.1.1 Virtual router default-
1072
Open Shortest Path First (OSPFv2 and OSPFv3)