Administrator Guide

Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Related
Commands
show ip ospf database — displays OSPF database information.
show ip ospf database router
Display the router (type 1) LSA information.
Z9000
Syntax
show ip ospf [process-id] database router [link-state-id] [adv-
router ip-address]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
link-state-id (OPTIONAL) Specify LSA ID in dotted decimal format. The
LSA ID value depends on the LSA type, and it can be one of
the following:
• the network’s IP address for Type 3 LSAs or Type 5 LSAs
• the router’s OSPF router ID for Type 1 LSAs or Type 4
LSAs
• the default destination (0.0.0.0) for Type 5 LSAs
adv-router ip-
address
(OPTIONAL) Enter the keywords adv-router followed by
the IP address of an Advertising Router to display only the
LSA information about that router.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.20 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
1088
Open Shortest Path First (OSPFv2 and OSPFv3)