Administrator Guide

Usage
Information
Use this command to make the FTP clients VRF aware. The VRF name that you
specify is used by the FTP client to reach the FTP server. If no VRF is specified, then
the default vrf is used.
ip telnet server enable
Enable the Telnet server on the switch.
Z9000
Syntax
ip telnet server enable
To disable the Telnet server, use the no ip telnet server enable command.
Defaults Enabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced on the E-Series.
Related
Commands
ip ssh server — enables the secure shell (SSH) server on the system.
ip telnet server vrf
Configures the TELNET server on either a specific VRF or a management VRF.
Z9000
Syntax ip telnet server vrf {management | vrf-name}
To undo the TELNET server configuration, use the no ip telnet server [vrf
vrf-name] command.
Control and Monitoring
109