Administrator Guide

show ip ospf routes
Display routes OSPF calculates and stores in OSPF RIB.
Z9000
Syntax
show ip ospf [process-id] routes
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series and E-Series.
Usage
Information
This command is useful in isolating routing problems between the OSPF and the
RTM. For example, if a route is missing from the RTM/FIB but is visible from the
display output of this command, the problem is with downloading the route to the
RTM.
This command has the following limitations:
• The display output is sorted by prefixes; intra-area ECMP routes are not
displayed together.
• For Type 2 external routes, Type 1 cost is not displayed.
Open Shortest Path First (OSPFv2 and OSPFv3)
1097