Administrator Guide

To return to the default time interval, enter no ipv6 ospf hello—interval.
Parameters
seconds
Enter the time interval in seconds as the time between hello
packets. The range is from 1 to 65525 seconds.
Defaults 10 seconds (Ethernet).
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0)
Introduced on the S4810 and Z9000.
Version 7.8.1.0 Added support for the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Version
8.3.19.0
Introduced on the S4820T.
Usage
Information
The time interval between hello packets must be the same for routers in a network.
Related
Commands
ipv6 ospf dead-interval – specifies the time interval between hello packets was
received from a router.
ipv6 ospf priority
To determine the Designated Router for the OSPFv3 network, set the priority of the interface.
Z-Series
Syntax
ipv6 ospf priority number
To return to the default time interval, use the no ipv6 ospf priority
command.
Parameters
number
Enter the number as the priority. The range is from 1 to 255.
Defaults 1
Command
Modes
INTERFACE
1126
Open Shortest Path First (OSPFv2 and OSPFv3)