Administrator Guide

Command
History
Version 9.2.
(0.0)
Added support for showing BFD status on the S4820T,
S4810, and Z9000.
Version 9.1.
(0.0)
Added support for OSPFv3 on the S4810 and Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 7.8.1.0 Added support for the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
If you enable BFD at the global level, show ipv6 ospf interface shows the BFD
provisioning.
If you enable BFD at the interface level, show ipv6 ospf interface shows the BFD
interval timers.
Example
Dell#show ipv6 ospf interface gigabitethernet 1/0
GigabitEthernet 1/0 is up, line protocol is up
Link Local Address fe80::201:e8ff:fe17:5bbd, Interface ID
67420217
Area 0, Process ID 1, Instance ID 0, Router ID 11.1.1.1
NetworkType BROADCAST, Cost: 1, Passive: No
Transmit Delay is 100 sec, State DR, Priority 1
Interface is using OSPF global mode BFD configuration.
Designated router on this network is 11.1.1.1 (local)
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 1,
Retransmit 5
Dell#
show ipv6 ospf neighbor
Display the OSPF neighbor information on a per-interface basis.
Z-Series
Syntax
show ipv6 ospf neighbor [interface]
Parameters
interface
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Open Shortest Path First (OSPFv2 and OSPFv3)
1139