Administrator Guide

To disable PIM debugging, use the no debug ip pim command or use the
undebug all to disable all debugging command.
Parameters
bsr (OPTIONAL) Enter the keyword bsr to view PIM Candidate
RP/BSR activities.
events (OPTIONAL) Enter the keyword group to view PIM messages
for a specific group.
group (OPTIONAL) Enter the keyword group to view PIM messages
for a specific group.
packet [in | out] (OPTIONAL) Enter the keyword packet to view PIM packets.
Enter one of the optional parameters:
• in: to view incoming packets
• out: to view outgoing packets
register (OPTIONAL) Enter the keyword register to view PIM
register address in dotted decimal format (A.B.C.D).
state (OPTIONAL) Enter the keyword state to view PIM state
changes.
timer [assert |
hello |
joinprune |
register]
(OPTIONAL) Enter the keyword timer to view PIM timers.
Enter one of the optional parameters:
• assert: to view the assertion timer
• hello: to view the PIM neighbor keepalive timer
• joinprune: to view the expiry timer (join/prune timer)
• register: to view the register suppression timer
Defaults Disabled.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.12.0
Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
PIM-Sparse Mode (PIM-SM)
1153