Administrator Guide

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series for the port-channels and the S-
Series.
Version 7.7.1.0 Introduced on the E-Series.
Example
Dell(conf)# ip access-list extended iptv-channels
Dell(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
Dell(config-ext-nacl)# permit ip any 232.1.1.0/24
Dell(config-ext-nacl)# permit ip 100.1.1.0/16 any
Dell(config-if-gi-1/1)# ip pim join-filter iptv-channels in
Dell(config-if-gi-1/1)# ip pim join-filter iptv-channels out
Related
Commands
ip access-list extended — configure an access list based on IP addresses or
protocols.
ip pim ingress-interface-map
When the Dell Networking system is the RP, statically map potential incoming interfaces to (*,G) entries
to create a lossless multicast forwarding environment.
Syntax
ip pim ingress-interface-map std-access-list
Parameters
std-access-list Enter the name of a standard access list.
Defaults none
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.4.1.0 Introduced
PIM-Sparse Mode (PIM-SM)
1157