Administrator Guide

source Enter the IPv4 or IPv6 source ip address or the source
interface. For IPv6 addresses, you may enter global
addresses only. Enter the IP address in A.B.C.D format.
• For a Port Channel interface, enter the keyword port-
channel then a number: The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Tunnel interface, enter the keyword tunnel then a
number from 1 to 16383.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
tos (IPv4 only) Enter the type of service required. The range is
from 0 to 255. The default is 0.
df-bit (IPv4 only) Enter Y or N for the “don't fragment” bit in IPv4
header.
• N: Do not set the “don't fragment” bit.
• Y: Do set “don't fragment” bit
Default is No.
validate-reply (IPv4 only) Enter Y or N for reply validation.
• N: Do not validate reply data.
• Y: Do validate reply data.
Default is No.
outgoing-
interface
(IPv6 link-local address) Enter the outgoing interface for ping
packets to a destination link-local address.
pattern pattern (IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF.
Default: 0xABCD.
sweep-min-
size
Enter the minimum size of datagram in sweep range. The
range is from 52 to 15359 bytes.
sweep-max-
size
Enter the maximum size of datagram in sweep range. The
range is from 53 to 15359 bytes.
sweep-interval Enter the incremental value for sweep size. The range is from
1 to 15308 seconds.
interface (IPv4 only) Enter the outgoing interface for multicast packets.
Enter the IP address in A.B.C.D format.
• For a Port Channel, enter the keyword port-channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Control and Monitoring
117