Administrator Guide

Version
8.3.12.0
Introduced on the S4810.
Version 8.4.1.1 Introduced on the E-Series ExaScale.
Usage
Information
The following describes the show ip pim snooping neighbor commands
shown in the following example.
Field Description
Neighbor address Displays the IP address of the neighbor learned through
PIM-SM snooping.
Interface Displays the VLAN ID number and slot/port on which the
PIM-SM-enabled neighbor was discovered.
Uptime/expires Displays the amount of time the neighbor has been up then
the amount of time until the neighbor is removed from the
multicast routing table (that is, until the neighbor hold time
expires).
Ver Displays the PIM version number:
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode:
• 1 = default Designated Router priority (use the ip pim
dr-priority command)
• DR = Designated Router
• S = Sparse mode
Example
Dell#show ip pim snooping neighbor
Neighbor Interface Uptime/Expires Ver DR Prio
Address
165.87.32.2 Vl 2 [Gi 4/13 ] 00:04:03/00:01:42 v2 1
165.87.32.10 Vl 2 [Gi 4/11 ] 00:00:46/00:01:29 v2 0
165.87.32.12 Vl 2 [Gi 4/20 ] 00:00:51/00:01:24 v2 0
show ip pim snooping tib
Display information from the tree information base (TIB) PIM-SM snooping discovered about multicast
group members and states.
Syntax
show ip pim snooping tib [vlan vlan-id] [group-address [source-
address]]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display TIB information PIM-
SM snooping discovered on a specified VLAN. The valid
VLAN IDs range is from 1 to 4094.
1172
PIM-Sparse Mode (PIM-SM)