Administrator Guide

Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 7.4.1.0 Introduced
ipv6 pim bsr-candidate
Configure the router as a bootstrap (BSR) candidate.
Z9500
Syntax
ipv6 pim bsr-candidate interface [hash-mask-length] [priority]
To disable the bootstrap candidate, use the no ipv6 pim bsr-candidate
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
hash-mask-
length
(OPTIONAL) Enter the hash mask length for RP selection.
The range is from 0 to 128. The default is 126.
priority (OPTIONAL) Enter the priority value for Bootstrap election
process. The range is from 0 to 255. The default is 0.
Defaults Refer to Parameters.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Introduced on the Z9500.
1180
PIM-Sparse Mode (PIM-SM)