Administrator Guide

ipv6 pim join-filter
Permit or deny PIM Join/Prune messages on an interface using an access list. This command prevents the
PIM-SM router from creating state based on multicast source and/or group.
Z9500
Syntax
ipv6 pim join-filter access-list
Parameters
access-list Enter the name of an extended access list.
in Enter the keyword in to apply the access list to inbound
traffic.
out Enter the keyword out to apply the access list to outbound
traffic.
Defaults none
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Introduced on the Z9500.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 7.3.1.0 Introduced
Example
Dell(conf)#ipv6 access-list JOIN-FIL_ACL
Dell(conf-ipv6-acl)#permit ipv6 165:87:34::0/112 ff0e::
225:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 any ff0e::230:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 165:87:32::0/112 any
Dell(conf-ipv6-acl)#exit
Dell(conf)#interface tengigabitethernet 0/84
Dell(conf-if-gi-0/84)#ipv6 pim join-filter JOIN-FIL_ACL in
Dell(conf-if-gi-0/84)#ipv6 pim join-filter JOIN-FIL_ACL out
ipv6 pim neighbor-filter
Prevent the system from forming a PIM adjacency with a neighboring system.
Z9500
Syntax
ipv6 pim neighbor-filter {access-list}
1182
PIM-Sparse Mode (PIM-SM)