Administrator Guide

ipv6 pim rp-address
Configure a static PIM rendezvous point (RP) address for a group. First-hop routers use this address to
send register packets on behalf of the source multicast host.
Z9500
Syntax
ipv6 pim rp-address address group-address group-address mask
override
To remove an RP address, use the no ipv6 pim re-address address group-
address mask override command.
Parameters
address Enter the IPv6 RP address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
group-address
group-address
mask
Enter the keywords group-address then the group address
in the x:x:x:x::x format and then the mask in /nn format to
assign that group address to the RP.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
override Enter the keyword override to override the BSR updates
with static RP. The override takes effect immediately during
enable/disable.
NOTE: This option is applicable to multicast group range.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Introduced on the Z9500.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 7.4.1.0 Introduced
PIM-Sparse Mode (PIM-SM)
1185