Administrator Guide

Defaults none
Command
Modes
INTERFACE VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Usage
Information
The list of secondary VLANs can be:
• Specified in comma-delimited or hyphenated-range format.
• Specified with this command even before they have been created.
• Amended by specifying the new secondary VLAN to be added to the list.
Related
Commands
private-vlan mode — sets the mode of the selected VLAN to community, isolated,
or primary.
switchport mode private-vlan — sets PVLAN mode of the selected port.
switchport mode private-vlan
Set PVLAN mode of the selected port.
Z9000
Syntax
[no] switchport mode private-vlan {host | promiscuous | trunk}
To remove PVLAN mode from the selected port, use the no switchport mode
private-vlan command.
Parameters
host Enter the keyword host to configure the selected port or
port channel as an isolated interface in a PVLAN.
promiscuous Enter the keyword promiscuous to configure the selected
port or port channel as an promiscuous interface.
trunk Enter the keyword trunk to configure the selected port or
port channel as a trunk port in a PVLAN.
Private VLAN (PVLAN)
1205