Administrator Guide

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The dot1p-priority command changes the priority of incoming traffic on the
interface. The system places traffic marked with a priority in the correct queue and
processes that traffic according to its queue.
When you set the priority for a port channel, the physical interfaces assigned to the
port channel are configured with the same value. You cannot assign the dot1p-
priority command to individual interfaces in a port channel.
rate police
Police the incoming traffic rate on the selected interface.
Z-Series
Syntax
rate police [kbps] committed-rate [burst-KB] [peak [kbps] peak-
rate [burst-KB]] [vlan vlan-id]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps). The range is from 0 to 40000000. The
default granularity is Megabits per second (Mbps).
committed-
rate
Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16
to 200000. The default is 50.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to
specify the peak rate in Mbps. The range is from 0 to 40000.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then a VLAN ID to
police traffic to those specific VLANs. The range is from 1 to
4094.
Defaults Granularity for commited-rate and peak-rate is Mbps unless you use the kbps
option.
Command
Modes
INTERFACE
Quality of Service (QoS)
1225