Administrator Guide

match mac vlan
Configure a match criterion for a class map based on VLAN ID.
Z9000
Syntax
match mac vlan number
Parameters
number Enter the VLAN ID. The range is from 1 to 4094.
Defaults none
Command
Modes
CLASS-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced.
Usage
Information
To access this command, enter the class-map command. You can match against
only one VLAN ID.
Related
Commands
class-map — identifies the class map.
policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part
of the policy map (output) applied on an interface.
Z9000
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate
qos-policy-name command.
Parameters
qos-policy-
name
Enter the name of the policy map in character format (32
characters maximum).
1240
Quality of Service (QoS)