Administrator Guide

Defaults none
Command
Modes
CONFIGURATION (policy-map-input and policy-map-output)
This command is supported on S-Series, S6000 and S4810 under policy-map-
input mode only.
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Related
Commands
policy-map-input — creates an input policy map.
policy-map-output — creates an output policy map (E-Series Only).
policy-map-input
Create an input policy map.
Z9000
Syntax
policy-map-input policy-map-name cpu-qos | [layer2]
To remove an input policy map, use the no policy-map-input policy-map-
name cpu-qos | [layer2] command.
Parameters
policy-map-
name
Enter the name of the policy map in character format (32
characters maximum).
cpu-qos Enter the cpu-qos keyword to assign this ACL to control
plane traffic only.
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2
Class Map. The default is Layer 3.
Quality of Service (QoS)
1241