Administrator Guide

Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
To assign traffic to different flows using QoS policy, use the Output Policy map.
This command enables Policy-Map-Output Configuration mode (conf-policy-
map-out).
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS
using policy maps.
service-policy output — applies an output policy map to the selected interface.
qos-policy-input
Create a QoS input policy on the router.
Z9000
Syntax
qos-policy-input qos-policy-name cpu-qos | layer2
To remove an existing input QoS policy from the router, use the no qos-policy-
input qos-policy-name cpu-qos | layer2 command.
Parameters
qos-policy-
name
Enter the name for the policy map in character format (32
characters maximum).
cpu-qos (OPTIONAL) Enter the keyword cpu-qos keyword to assign
this ACL to control plane traffic only.
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2
Class Map. The default is Layer 3.
Quality of Service (QoS)
1243