Administrator Guide

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
Use this command to specify the name of the output QoS policy. Once output
policy is specified, rate-shape, scheduler strict, bandwidth-percentage, and WRED
can be defined. This command enables the qos-policy-output configuration mode
—(conf-qos-policy-out).
When rate-shape in QoS policy is applied both on queue level and aggregate
mode, the queue-based shaping occurs first followed by the aggregate rate
shaping.
Related
Commands
bandwidth-percentage — assigns weight to the class/queue.
wred — assigns yellow or green drop precedence.
queue egress
Assign a WRED Curve to all eight egress Multicast queues or designate the percentage for the Multicast
bandwidth queue.
Syntax
queue egress multicast linecard {slot number port-set number |
all} [wred-profile name | multicast-bandwidth percentage]
To return to the default, use the no queue egress multicast linecard
{slot number port-set number | all} [wred-profile name |
multicast-bandwidth percentage] command.
Parameters
linecard
number
Enter the keyword linecard then the line card slot number.
port-set
number
Enter the keywords port-set then the line card’s port pipe.
The range is from 0 or 1.
all Enter the keyword all to apply to all line cards.
Quality of Service (QoS)
1245